DSIMAN Servo Motor Reset & other Modes
Restore Factory Modes:
Method 1: Enter Parameter Setting, display "P00",
long press "S" for 3 seconds,
and the parameter will be automatically restored.
Method 2: Press the "P" key to power on, its restore all parameters
Password Mode:
Press "P Key" + "- Key" to enter the password mode and display "0000"
Press "P" Key to move left and right, the current number will flash, press "+", "-" key to adjust the value; After setting, press "S" to confirm; If the password is wrong, it will switch to standby mode. If correct, display "P00", adjust to "P01" and set the maximum speed.
Monitoring Mode:
Press "P" Key + "S Key" to enter the monitoring mode, c-xx will be displayed. Press "p" Key to display the corresponding monitoring value. Long press "S" Key to return to standby mode.
C-01: Actual motor speed
C-02: AC incoming voltage (for reference only when shut down)
Plant Aging Mode:
Press S to power on, the system enters the aging mode;
Method 1. In this mode, press "S' and "+" to start the motor running, and press "S" and "-" to stop the motor;
Method 2. Click on the pedal once to start aging, and then click on the pedal again to stop; Pay attention do not mix to the panel start stop and pedal start stop.